Skip to main content

Standby generator installs for Dallas homes and businesses through an independent, licensed installer

Outage Ready GeneratorsGet Installation Quote

Generator Installation in Irving, TX

Irving covers about 67 square miles, from older streets on the east side to the master-planned blocks of Las Colinas and Valley Ranch, plus part of DFW Airport. A generator job in one corner of the city can look nothing like one a few miles away.

Need a standby generator in Irving? Use the form to tell us the address, the size of the house or building and what must stay on. Outage Ready Generators forwards it to an independent licensed electrical contractor who installs in Irving. They inspect the site, size the unit, handle permits and quote in writing, and you choose whether to go ahead.

Get Installation Quote Our service area

Get an installation quote

We send your request to one independent, licensed installer. Asking is free. How referrals work

Standby generator on a concrete pad beside a brick home

Three parts of Irving, three kinds of job

East Irving

Wikipedia notes that eastern Irving holds older neighborhoods than the rest of the city. Older homes there tend to have smaller lots and original panels. The pro checks both: room for the pad with proper clearances, and room in the panel for a transfer switch.

Las Colinas

Las Colinas is a mixed-use, master-planned community covering more than 12,000 acres, and Irving hosts the headquarters of several large companies. Office suites, condos and data rooms there usually call for commercial generator installation, with larger units and more paperwork. If an owners' association governs your property, ask early whether it reviews outdoor equipment.

Valley Ranch

Valley Ranch is another master-planned area, mostly homes. Many owners there want a whole home standby generator sized for the full house instead of a few circuits.

Oncor carries the power

Oncor delivers electricity in Irving, reads the meters and handles outages, while residents choose their own retail plan. A standby unit never sends power back onto Oncor's lines. The switch separates your building first.

Gas, trades and brands

Most home standby units here burn natural gas. That brings a second trade onto the job: a plumber licensed by the Texas State Board of Plumbing Examiners runs the gas line, while the electrician, licensed by TDLR, wires the unit. Generac and other makers all sell units in Irving. We do not represent any of them.

What the visit covers

  • Your load: AC units, pool gear, kitchen, medical devices.
  • Gas service size and the route a new line would take.
  • Where the unit can sit, given setbacks, easements and noise.
  • Permits from the City of Irving and any association approval.

About 256,700 people lived in Irving at the 2020 census, so demand after a big storm can run high. Asking for a quote before outage season helps.

Close by: Coppell and Farmers Branch. More on the city at Wikipedia.

Services available in Irving

Generator questions

Do you take generator requests near DFW Airport in Irving?

Yes, for homes and businesses inside Irving. The airport itself is not a project we handle.

Can an Irving office building get a standby unit through your form?

Yes. Describe the building, the tenants and what must stay on. The request goes to a contractor who does commercial work.

What should an Irving homeowner ask before signing a generator quote?

Ask which brand and size is quoted and why, whether the permit and gas work are included, who books the inspections, and what yearly service costs. Compare two written quotes if you can.

Who handles outages on Irving power lines?

Oncor. It owns the wires and restores service. Your generator covers the gap until it does.